FabCar is a project in which students fabricate most of the individual components of the vehicle. Some of the parts are provided, and students create what they need to make an electric car that can move around either with a remote control or autonomously. The basic car can be made in about one term of 70 minute periods meeting three to four times a week. This project is a good followup to the FoamJumper project.

Here are photos of the project: http://flickr.com/search/?q=fabcar&w=13559856%40N00

Materials:
two dc motors
wire
copper clad board
screws
1/2" plywood
1/4" luan plywood
cds for wheels
center adaptors for cds
1/8" threaded rod with nuts
double push double throw switches, two or more for each car
crown gear
rubber band for belt

Fabricated materials (these were made on the lasercutter)
dc motor holders cut to fit snugly on the dc motors
pulleys with an interior dimension of .12 inch and 4" outer dimension

tools
hacksaw for cutting threaded rod
pliers
soldering iron
screwdrivers

 Create your own educational wiki!HelpPublic, not yet premium Privacy Policy RSS